Find your diagram.
Choose your pump type or the combined configuration and see where each device fits.
X-PURA with a pump in the tank.
X-PURA is installed on the water line leaving the tank and sanitises the water as it flows, before it reaches the taps.
- Locate the water line leaving the tank.
- Check the fittings and the 12 V power supply for X-PURA.
- Follow the wiring diagram.
With a submersible pump, install X-PURA: X-TANK is designed for 12 V external pumps.
X-PURA with an external pump.
X-PURA is installed on the water line and also works without X-TANK. The diagram shows the circuit with an external pump.
- Check the pump specifications: X-PURA is suitable for up to 10 l/min.
- Locate the point in the circuit where X-PURA will be fitted.
- Compare the connections with the diagram.
Would you also like a steadier flow? X-TANK goes in place of the expansion vessel: see the X-PURA + X-TANK configuration.
Sanitisation and control, together.
In systems with a 12 V external pump, X-TANK replaces the expansion vessel and controls the pump, with a dedicated output to power X-PURA. X-PURA sanitises the water along the line.
- Check that the pump is an external 12 V pump with a built-in pressure switch.
- X-TANK goes in place of the expansion vessel.
- Connect X-PURA to the dedicated X-TANK output, as shown in the diagram.
The diagrams are for guidance only: for installation, follow the instructions supplied with the products.
The information
to have at hand.
Name, type and specifications shown on the label.
12 V system; for X-PURA, pump up to 10 l/min.
Check pipes, connections and mounting position.
Questions about your system?
Tell us about your pump and we will find the right configuration together.
